Caller Id Service On T1 Line - Panasonic KX-TD500 Features Manual

Caller ID Service on T1 Line

Description
Provides the display PT user with a caller's information, such as telephone number (max. 24
digits), sent from the T1 Central Office over the CO line assigned to receive Caller ID service
calls.
Conditions
• A special arrangement is required with the telephone company to utilize the Caller ID
Service.
• Caller ID Number and Name Registration
Up to 1000 entries of number and name for Caller ID Service can be programmed either by
User or System Programming.
• Tenant Service
If "Tenant Service" is employed, up to 2000 entries of number and name for Caller ID
Service can be shared among each tenant under the condition of up to 1000 entries per
tenant.
• If neither the telephone number nor the name is stored in the Caller ID Table, the number
sent from Caller ID service is displayed.
• If the network provides a telephone number only, the system searches for the matching
name for the number from the Caller ID Table and displays both of them.
• Call Log, Incoming
A Caller ID information is recorded in the Call Log of a display DPT (KX-T7230, KX-
T7235, KX-T7433, KX-T7436) either automatically or manually.
• A display PT with one-line readout (KX-T7431 and display APTs) will show either the
name or the number at a time. To alternate the display, press the
• Initial Display Selection
If Caller ID is available, the initial display (Caller ID, DID Name or CO Line Name) is
determined either by Station or System Programming. Caller ID Detection is set by System
Programming <Section 4.2 Trunk Line, "Caller ID" in the Programming Guide>.
CO Line Name can be changed by System Programming <Section 4.2 Trunk Line, "Name"
in the Programming Guide>.
• Display Selection While Receiving Caller ID
While receiving Caller ID, the extension user can alternate the display (Caller ID, DID
Name or CO Line Name) by pressing the SHIFT or " " button.
• Caller ID or Call Duration
During a call, the extension user can alternate the display (Caller ID or Duration) by
pressing the "INFO" or FWD/DND button.
• This feature is available when the Caller ID is assigned to "Enable." In addition, a channel
of T1 card must be assigned as "DID" or a channel of T1 card must be assigned as
"TIE(E&M)" and the incoming type must be assigned as "DIL" by System Programming.
Features Guide
General Features
key.
119