Rs-232 Host Port Command Summary - Fluke 5080A Operator's Manual

Command
LCOMP? Returns whether inductive load compensation for ac current output is active.
OPER Activates the Calibrator output if it is in standby.
OPER? Returns the operate/standby setting.
OUT Sets the output of the Calibrator and establishes a new reference point for the error
mode.
OUT? Returns the output amplitudes and frequency of the Calibrator.
PHASE Sets the phase difference between the NORMAL and AUX terminals for dual outputs.
The NORMAL terminal output is the phase reference.
PHASE? Returns the phase difference between the NORMAL and AUX terminals.
POWER? Returns the equivalent power for dc and ac power output.
RANGE? Returns the present output ranges.
RANGELCK Locks in the present range, or selects auto ranging.
RANGELCK? Returns whether or not the preset output range is locked.
STBY Puts the Calibrator in standby.
ZCOMP Activates (2-wire or 4-wire) or deactivates impedance compensation.
ZCOMP? Returns whether or not impedance compensation is active and, if active, which type.
Command
LOCAL Puts the Calibrator into the local state.
LOCKOUT Puts the Calibrator into the lockout state. This command duplicates the IEEE-488 LLO
(Local Lockout) message.
REMOTE Puts the Calibrator into the remote state. This command duplicates the IEEE-488 REN
(Remote Enable) message.
SPLSTR Sets the serial remote mode Serial Poll response string.
SPLSTR? Returns the string programmed for serial remote mode Serial Poll responses.
SRQSTR Sets the serial remote mode SRQ (Service Request) response (up to 40 characters).
SRQSTR? Returns the string programmed for Serial Mode SRQ response.
^P (<cntl>p) Control-P character prints the serial poll string. (See SPLSTR for string format.)
^C (<cntl>c) Control-C character clears the device.
Table 6-4. Output Command Summary (cont.)
Table 6-5. RS-232 Host Port Command Summary
Command Summary by Function
Description
Description
6
Remote Commands
6-5