Table of Contents
Advertisement
Appendix A Troubleshooting
The print setting of a job does not correspond to the result of printing.
1.
Check that the printer setting is not changed.
Refer to "Chapter 3 Printer Driver Functions
7).
Memory Overflow
1.
Depending on the functions selected in the printer driver, occasional
memory overflow may occur if the volume of the print job is large. In this
case the print job is cancelled.
e.g., Booklet, Fold & Stitch, 2 in 1, etc.
In case of frequent Memory Overflow it is recommended that you extend the memory
capacity in the main body printer (copier).
When an error message "Print Controller Memory Overflow" is displayed on the LCD
Touch Screen using Duplex printing or Application function, you may cancel the print job
and retry to print with another function.
HD Full
Hard-disk full occurs when 1% of total disk capacity is used by the print/scan
jobs; If the disk capacity is 2 GB, the HD Full is 20 MB free space.
Under the HD Full condition, the following message is displayed on the front
panel of the main body printer.
Printer HD Full
Please free HD space
1.
Remove the scan job in the HD on network computer via ftp.
Refer to "Chapter 5 Scanner Operation
the scanned data.
2.
Output the password print job in the HD from control panel.
3.
When the [Delete After 24H] is selected in the [Set Default] - [Scan Data
AutoDel.] on the control panel of the Copier, the print controller automatic
timer deletes the jobs from the HD which exists for more than 24 hours.
Under HD Full:
The print job can not be printed.
If the scan job starts, the job is canceled automatically. The following message is
displayed on the control panel.
Printer HD Full
Scan JOB was canceled
You may want to view the scan job canceled at this time.
To do this, touch [NON COMPLETE JOB LIST] in the Job Status Screen.
Appendix A-4 Print Controller INSTRUCTION MANUAL
Function List" for the printer setting" (p. 3-
To Delete Scanned Data" (p. 5-19) for deletion
Advertisement
Table of Contents
