Table of Contents
Advertisement
Hardware Configuration
Basic Configuration
Configuration of the print controller is as follows:
Architecture:
IBM Compatible PC System
Processor:
Intel Pentium III 500 MHz
Memory:
64 MB standard / 512 MB max. (option)
Hard Drive:
IDE compatible 2.0 GB min.
Floppy Drive:
3.5" Floppy Disk 1.44 MB
Interface
Parallel
Centronics (IEEE 1284)
Ethernet (option)
100BaseTX and 10BaseT
The optional network interface card is used to connect to the Ethernet. This card
is the internal network interface card which supports multiple protocols on the
Ethernet. This card includes a CPU and flash memory with an upgradable pro-
gram.
The network interface card supports the following network protocols.
IPX/SPX (NetWare, Peer to Peer)
TCP/IP
(LPD/LPR, Peer to Peer)
AppleTalk (EtherTalk)
Refer to the corresponding operating manual for how to use the network interface
card.
Do not use the parallel port with the Ethernet interface. Otherwise, a
system error may occur.
IEEE 1394
The maximum transferring rate is 200 Mbps.
Use the Konica engine interface only to connect the print controller and
the main body printer. Otherwise, a system error may occur.
Chapter 1 Overview
Print Controller INSTRUCTION MANUAL 1-5
Advertisement
Table of Contents
