Belt Replacement - Ransomes EC Hydro Midsize 930325 Safety And Operation Manual

BELT REPLACEMENT

PTO BELT
1. Rotate idler arm using a 3/8" ratchet or breaker
bar and remove belt.
CUTTERDECK BELT
1. Remove PTO belt.
2. Rotate idler arm using a 3/8" ratchet or breaker
bar and remove belt.
3. Replace in the reverse order.
PUMP DRIVE BELT
1. Remove PTO belt from the engine clutch.
2. Disconnect the clutch wire harness.
3. Unbolt clutch bracket from clutch and rotate the
clutch to allow enough clearance to remove the
clutch bracket.
4. Rotate idler arm using a 3/8" ratchet or breaker
bar inserted into the square hole in the idler arm.
5. Remove pump drive belt.
6. Replace by following steps in reverse order.
GB-16
EC
Hydro
Midsize
View under engine deck