Agilent Technologies 81150A Getting Started Manual page 27

Selecting a Pulse
Waveform
81150A and 81160A Getting Started Guide
To set the operating mode and trigger mode as required, do the following:
Before setting any values, press the Store/Recall key and press the

Set to Defaults softkey. Confirm the action by pressing the Yes
softkey.
Press Ch 1 key to select channel 1.

Press the normal and inverted output keys to enable both outputs of

channel 1.
The Continuous trigger mode is enabled by default. Therefore, we

only need to select a Pulse waveform. To select a Pulse waveform,
simply press the Pulse key given on the Front Panel. This brings you
to the screen shown below.
Getting Started
27