Stihl MS 200 Instruction Manual page 38

English
N Afterwards, dress the leading edge
of the depth gauge parallel to the
service mark (see arrow) – when
doing this, be careful not to further
lower the highest point of the depth
gauge
Sharpening tools (special accessories)
Chain pitch Round file ^
Inches (mm) mm (Inches) Part number
1/4 (6.35) 4.0 (5/32)
3/8 P (9.32) 4.0 (5/32)
0.325 (8.25) 4.8 (3/16)
3/8 (9.32) 5.2 (13/64)
0.404 (10.26) 5.5 (7/32)
1)
consisting of file holder with round file, taper square file and file gauge
36
Depth gauges that are too low
increase the kickback tendency of
the chain saw.
N Lay the file gauge on the saw chain
– the highest point of the depth
gauge must be flush with the file
gauge
Round file File holder
Part number
5605 772 4006 5605 750 4327
5605 772 4006 5605 750 4327
5605 772 4806 5605 750 4328
5605 772 5206 5605 750 4329
5605 772 5506 5605 750 4330
RSC3, RMC3, PMC3, PMMC3
The upper part of the humped drive link
(with service mark) is lowered at the
same time as the depth gauge of the
cutter.
The rest of the humped drive link
must not be filed; otherwise, this
could increase the tendency of the
chain saw to kick back.
N After sharpening, clean the saw
chain thoroughly, removing any
filings or grinding dust – lubricate
the saw chain thoroughly
N In the event of extended periods of
disuse, store saw chains in cleaned
and oiled condition
File gauge Taper square file Sharpening set
Part number Part number
1110 893 4000 0814 252 3356
1110 893 4000 0814 252 3356
1110 893 4000 0814 252 3356
1110 893 4000 0814 252 3356
1106 893 4000 0814 252 3356
1)
Part number
5605 007 1027
5605 007 1027
5605 007 1028
5605 007 1029
5605 007 1030
MS 200