Stihl MS 200 Instruction Manual page 24

English
To set the Master Control lever to warm
start n, first set it to cold start l, then
push the Master Control lever into the
warm start n position.
Changing to warm start n is only
possible from the cold start l position.
When the throttle trigger is squeezed,
the Master Control lever returns from
warm start n to the operating
position F.
To switch off the engine, set the Master
Control lever to Stop 0.
Holding the chain saw
There are two ways to hold the chain
saw during starting.
22
On the ground
N Place the chain saw securely on the
ground – assume a steady stance –
the saw chain must not touch any
objects and also must not touch the
ground
N With the left hand on handlebar,
press the chain saw firmly against
the ground – thumb wrapped
around the handlebar
N Place your right foot through the
rear handle
Between the knees or thighs
N clamp the rear handle between the
knees or thighs
N grip the handlebar firmly with the left
hand – thumb wrapped around the
handlebar
Starting the engine
There must not be anyone within
the swivel range of the chain saw.
Observe safety precautions.
MS 200