Installing The Memory Card (Flash Memory Card And/Or Dram Card) - Panasonic UF-890/990 Operating Instructions Manual

Options and Supplies

Installing the Memory Card (Flash Memory Card and/or DRAM Card)

Before installing, make sure that there is no document file(s) stored in the memory. You may confirm by
printing out a File List (See page 78). When the memory card is installed, the machine will initialize the
document memory, all contents stored in the document memory at that time will be lost.
1
2
3
2
4
NOTE
158
2
FLASH
1. The document(s) stored in memory will be lost if the memory card is removed.
2. After installing the DRAM Card, set Fax Parameter No. 60 to the size of the Card.
3. The memory size on Fax Parameter No.99 is only shown for the Flash Memory Card.
Memory Card Cover
3
D-RAM
1
(1) Turn the Power Switch to the "O" (OFF)
position located in the rear of the machine.
(2) Open the ADF Door.
(3) Remove a Screw.
(4) Remove the Memory Card Cover.
Insert the Memory Card(s) gently into the card
slot with the Panasonic logo facing to the rear.
(See Note 2)
Caution: Installing the Memory Card(s) in
the wrong direction may damage
the connecting pins inside the
machine.
(1) Re-install the Memory Card Cover and the
Screw to secure the Cover.
(2) Close the ADF Door.
Turn the Power Switch to the "I" (ON) position.
Print out the Fax Parameter List (See page
138) and confirm that the memory size on Fax
Parameter No. 99. (See page 39 and the Note 3
below)