Removing the top cover
WARNING: Before working inside your Embedded Box PC, read the
safety information that shipped with your Embedded Box PC and
follow the steps in
After working inside your Embedded Box PC, follow the steps in
working inside your Embedded Box
see the Regulatory Compliance home page at
regulatory_compliance.
Prerequisites
1
Follow step 1 to step 6 in
2
Remove the
3
Remove the
Procedure
1
Disconnect the power-switch cable and remove it from the routing
guides on the chassis.
2
Disconnect the power-connector cable and intrusion-switch cable from
the system board.
3
Remove the screw that secures the grounding cable to the system board.
Before working inside your Embedded Box
"Removing the back
PCI/PCIe card
(if installed).
riser
card.
PC. For more safety best practices,
www.dell.com/
cover".
PC.
After
95