Replacing The Intrusion Switch; Procedure; Post-Requisites - Dell Embedded Box PC 5000 Service Manual

Replacing the intrusion switch

WARNING: Before working inside your Embedded Box PC, read the
safety information that shipped with your Embedded Box PC and
follow the steps in
After working inside your Embedded Box PC, follow the steps in
working inside your Embedded Box
see the Regulatory Compliance home page at
regulatory_compliance.

Procedure

1 Replace the screw that secures the intrusion switch to the chassis.
2 Route the intrusion-switch cable through the routing guides on the
chassis and under the heat sink pipe.
3 Connect the intrusion-switch cable to the intrusion-switch connector on
the system board.

Post-requisites

1 Replace the PCI/PCIe card
2 Follow step 2 to step 9 in
86
Before working inside your Embedded Box
(if necessary).
"Replacing the back
PC. For more safety best practices,
www.dell.com/
cover".
PC.
After