Removing The Intrusion Switch; Prerequisites; Procedure - Dell Embedded Box PC 5000 Service Manual

Removing the intrusion switch

WARNING: Before working inside your Embedded Box PC, read the
safety information that shipped with your Embedded Box PC and
follow the steps in
After working inside your Embedded Box PC, follow the steps in
working inside your Embedded Box
see the Regulatory Compliance home page at
regulatory_compliance.

Prerequisites

1 Follow step 1 to step 6 in
2 Remove the

Procedure

1 Disconnect the intrusion-switch cable from intrusion-switch connector
on the system board.
2 Remove the intrusion-switch cable from the routing guides on the
chassis.
3 Slide the cable out from under the heat sink pipe.
4 Remove the screw that secures the intrusion switch to the chassis.
84
Before working inside your Embedded Box
"Removing the back
PCI/PCIe card (if installed).
PC. For more safety best practices,
www.dell.com/
cover".
PC.
After