Recommended Tools - Dell Embedded Box PC 5000 Service Manual

WARNING: Disconnect all power sources before opening the
Embedded Box PC cover or panels. After you finish working inside the
Embedded Box PC, replace all covers, panels, and screws before
connecting to the electrical outlet.
CAUTION: To avoid damaging the Embedded Box PC, ensure that the
work surface is flat and clean.
CAUTION: To avoid damaging the components and cards, handle
them by their edges, and avoid touching pins and contacts.
CAUTION: You should only perform troubleshooting and repairs as
authorized or directed by the Dell technical assistance team. Damage
due to servicing that is not authorized by Dell is not covered by your
warranty. See the safety instructions that shipped with the product or
at www.dell.com/regulatory_compliance.
CAUTION: Before touching anything inside your Embedded Box PC,
ground yourself by touching an unpainted metal surface, such as the
metal at the back of the Embedded Box PC. While you work,
periodically touch an unpainted metal surface to dissipate static
electricity, which could harm internal components.
CAUTION: When you disconnect a cable, pull on its connector or on
its pull tab, not on the cable itself. Some cables have connectors with
locking tabs or thumb-screws that you must disengage before
disconnecting the cable. When disconnecting cables, keep them
evenly aligned to avoid bending any connector pins. When connecting
cables, ensure that the ports and connectors are correctly oriented
and aligned.
CAUTION: Press and eject any installed card from the media-card
reader.

Recommended tools

The procedures in this document may require the following tools:
• Philips screwdriver
• Flat-head screwdriver
• Plastic scribe
• Hex screwdriver
• 8 mm open wrench
11