Before You Begin; Set Up The Printer - DataCard CD800 Quick Install Manual

CLM Laminator Quick Install and Upgrade Guide

Before You Begin

• This laminating system requires that the printer and laminator
firmware is at the same version level for both parts of the
system. The minimum firmware version is D3.15.x-x. Check
the printer LCD panel to see the installed firmware version.

If your firmware is not at the required minimum level, or if you
receive a firmware version mismatch error (message 222),
use the Card Printer Firmware Update program and
instructions (included on the enclosed CD) to update the
firmware. Or, visit
firmware.
• CD800 systems with serial number 20,000 and above.
You may need to perform the firmware update twice. The first
update allows the printer to communicate with the laminator.
The second update upgrades the laminator firmware.
• Refer to the printer's Installation and Administrator's
Guide, found on the Owner's Library CD that ships with
the printer, for detailed installation instructions. The latest
user documentation and firmware for your printer and CLM
laminator is available for download at www.datacard.com.
Your laminator may look different from the one shown in the
illustrations, based on the options installed. The procedures
described in this guide apply to all CLM laminators.

1. Set Up the Printer

Refer to the Quick Install Guide shipped with your printer to
set up the printer and load printer supplies.
2
www.datacard.com to download the latest
CLM Laminator