Jeep Renegade 2016 Owner's Manual page 109

The sensitivity of the system can be adjusted with the
multifunction lever. Wiper delay position one is the least
sensitive, and wiper delay position two is the most
sensitive. Place the wiper switch in the OFF position
when not using the system.
Rain Sensing Wipers – Inhibition
When the user switches the ignition to STOP, leaving the
lever in intermittent positions, no wipe cycle is per-
formed for safety reasons. This temporary inhibition
avoids accidental activations of the wiping (e.g during
the hand washing of the windscreen, blocking the blades
in ice/snow conditions). The user can activate the Rain
Sensing Wipers in three ways:
• Moving the level in OFF position and then in Intermit-
tent positions.
• One MIST command actuation.
GETTING TO KNOW YOUR VEHICLE 107
• The vehicle speed exceeds 3 mph (5 km/h) and the
rain sensor detects the presence of rain.
NOTE:
• The Rain Sensing feature will not operate when the
wiper switch is in the low or high-speed position.
• The Rain Sensing feature may not function properly
when ice, or dried salt water is present on the wind-
shield.
• Use of Rain-X or products containing wax or silicone
may reduce Rain Sensing performance.
• The Rain Sensing feature can be turned on and off
using the Uconnect System, refer to "Uconnect Set-
tings" in "Multimedia" for further information.
4