Wireless Antennas - HP 260 G2 Maintenance And Service Manual

Wireless antennas

The antenna cables route from the WLAN module to antennas on the front near the speaker and on the rear of
the chassis.
To replace the antennas:
1. Prepare the computer for disassembly
2. Remove the access panel
3. Remove the hard drive
4. Disconnect the antenna cables from the WLAN module
5. Remove the speaker
6. Remove the fan
7. Remove the heat sink
8. Remove the drive cage
9. Remove the system board
10. Remove the antenna from the front of the computer by pressing the tab on the inside of the computer to
disengage the antenna.
34 Chapter 4 Removal and replacement procedures
(Preparation for disassembly on page
(Access panel on page
(Hard drive on page
(Speaker on page 22).
(Fan on page 24).
(Heat sink on page
(Drive cage and drive cable on page
(System board on page
14).
15).
(WLAN module on page
27).
28).
30).
13).
21).