Antennas - HP ProDesk 405 G4 Small Form Factor Maintenance And Service Manual

Antennas

The antennas route from the WLAN module to the front and the rear of the computer.
1. Prepare the computer for disassembly
2. Remove the access panel
3. Remove the front bezel
4. Remove the drive cage
5. Disconnect the internal antennas from the WLAN module
6. Remove the antenna cable from the clips on the inside of the I/O bracket.
7. From the front of the computer, remove the Torx screw that secures the antenna to the front of
the computer.
8. Detach the antenna transceiver from the computer, and then release the antenna through the opening (2)
and away from the computer.
50 Chapter 4 Removal and replacement procedures
(Preparation for disassembly on page
(Access panel on page 18).
(Front bezel on page 19).
(Drive cage on page 22).
17).
(WLAN module on page 43).