Drive Cage And Drive Cable - HP 260 G2 Maintenance And Service Manual

Drive cage and drive cable

The drive cage is located next to the heat sink and is secured with three Torx screws. The drive cable connects
to the system board under in the drive cage. You have to remove the drive cage to access the drive cable
connector underneath.
1. Prepare the computer for disassembly
2. Remove the access panel
3. Remove the hard drive
4. Remove the three Torx screws (1) that secure the drive cage to the computer.
28 Chapter 4 Removal and replacement procedures
(Preparation for disassembly on page
(Access panel on page
(Hard drive on page 15).
14).
13).