Comtech EF Data DT-4572 Installation And Operation Manual page 14

DT-4572 X-Band Down Converter
Table of Contents
8.7.2.16 SRO (Set Reference Oscillator Tuning) ......................................... 8-16
8.7.2.17 SSA (Converter Slope Adjustment) .............................................. 8-16
8.7.2.18 RET (Equipment Type) .................................................................. 8-17
8.7.2.19 PNM (Part Number) ..................................................................... 8-17
8.7.2.20 FRW (Legacy Firmware Information) ........................................... 8-17
8.7.2.21 FRM (Firmware Information) ....................................................... 8-18
8.7.2.22 IMG (Firmware Image) ................................................................. 8-18
8.7.2.23 AID (Application Identification) .................................................... 8-19
8.7.2.24 FRB (Force Reboot) ...................................................................... 8-19
8.7.3 Configuration Commands / Queries .................................................. 8-20
8.7.3.1 FRE (Frequency) ........................................................................... 8-20
8.7.3.2 IFF (IF Frequency) ......................................................................... 8-20
8.7.3.3 ATT (Attenuation) ......................................................................... 8-21
8.7.3.4 CLD (Cold Start) ............................................................................ 8-21
8.7.3.5 MUT (RF Mute)............................................................................. 8-21
8.7.3.6 CMM (Configure Mute Mode) ..................................................... 8-22
8.7.3.7 CRM (Redundancy Mute Mode) .................................................. 8-22
8.7.3.8 AFR (Auto Fault Recovery) ........................................................... 8-22
8.7.3.9 PGM (Program Pre-select) ........................................................... 8-23
8.7.3.10 DPS (Display All Pre-selects) ......................................................... 8-23
8.7.3.11 CLR (Clear Pre-select Configuration) ............................................ 8-24
8.7.3.12 SEL (Select Pre-select Configuration) ........................................... 8-24
8.7.4 Operating Modes ............................................................................... 8-24
8.7.4.1 RED (Redundant Mode) ............................................................... 8-24
8.7.4.2 ICT (Initialize Chain Command) .................................................... 8-25
8.7.4.3 SAM (Switching Automatic/Manual Mode) ................................. 8-25
8.7.4.4 FBU (Force Backup) ...................................................................... 8-26
8.7.5 Status Queries .................................................................................... 8-27
8.7.5.1 RCS (Configuration Status) ........................................................... 8-27
8.7.5.2 RMS (Maintenance Status) .......................................................... 8-27
8.7.5.3 RUS (Utility Status) ....................................................................... 8-28
8.7.5.4 RAS (Alarm Status) ....................................................................... 8-28
8.7.5.5 SAS (Summary Alarm Status) ....................................................... 8-28
8.7.5.6 TSC (Terminal Status Change) ...................................................... 8-29
8.7.5.7 PACRCS (Packed Configuration Status) ......................................... 8-29
8.7.5.8 PACRMS (Packed Maintenance Status) ........................................ 8-30
8.7.5.9 PACRAS (Packed Alarm Status) ..................................................... 8-30
8.7.5.10 PACRUS (Packed Utility Status) .................................................... 8-31
8.7.6 Stored Alarms ..................................................................................... 8-32
MN/DT4572.IOM / CD-MNDT4572
xii
Revision 1