AEG L 98699 FL User Manual page 36

36 www.aeg.com
Without the plastic hose guide.
• On the edge of a sink.
• Make sure that the plastic guide can-
not move when the appliance drains.
Attach the guide to the water tap or
the wall.
• To a stand pipe with vent-hole.
Refer to the illustration. Directly into a
drain pipe at a height of not less than
60 cm (23.6") and not more than 100
cm (39.3"). The end of the drain hose
must always be ventilated , i.e. the in-
ner diameter of the drainpipe (min. 38
mm — min. 1.5") must be larger than
the external diameter of the drain
hose.
• If the end of the drain hose is this (see
the drawing), you can push it directly
into the stand pipe.
• To a sink spigot.
Refer to the illustration. Put the drain
hose in the spigot and tighten it with a
clip. Make sure that the drain hose
makes a loop to prevent that remain-
ing particles go in the appliance from
the sink.