Using The Base Unit - Panasonic KX-TG5230C Operating Instructions Manual

Making Calls

Using the Base Unit

1
Press [SP-PHONE].
• The indicator lights.
2
Dial a phone number.
• If you misdial, press [SP-PHONE]
and start again from step 1.
3
When the other party answers,
speak into the MIC (microphone).
4
To hang up, press [SP-PHONE].
• The indicator light goes out.
• To switch to the handset while using the base unit speakerphone:
— If the handset is off the base unit, press [C] or [s] on the handset, then press
[SP-PHONE] on the base unit.
— If the handset is on the base unit, just lift up.
Hands-free Digital Duplex Speakerphone
For best performance, please note the following:
• Speak alternately with the other party in a quiet room.
• If you or the other party has difficulty hearing, press [d] to decrease the
speaker volume.
To adjust the speaker volume
To increase volume, press [B]. To decrease volume, press [d].
• There are 8 volume levels. If you try to increase/decrease volume when it is at the
maximum/minimum level, the base unit beeps 3 times.
To redial the last number dialed
Press [SP-PHONE], then press [REDIAL/PAUSE].
To put a call on hold
Press [HOLD] during a conversation.
• The SP-PHONE indicator and IN USE indicator flash.
To return to the call, press [SP-PHONE].
• The handset users can also take the call by pressing [C] or [s].
• If another phone is connected on the same line (p. 11), you can also take the call
by lifting its handset.
• If a call is kept on hold for 6 minutes, an alarm tone will start to sound. After 4
additional minutes on hold the call will be disconnected.
26
Base Unit
IN USE
Indicator
[REDIAL/PAUSE]
[B], [d]
MIC
[HOLD]
[SP-PHONE]
and Indicator