Programming via direct commands
You can also programme most features using "direct commands"—special codes that take
you directly to the feature you wish to programme and allow you to select the desired
setting. There is no need to scroll through the unit's menus.
Details of each feature can be found on the corresponding pages.
1
Press {MENU}.
2
Enter the desired feature code (shown below).
3
Enter the desired setting code (shown below).
L This step may vary depending on the feature being programmed.
4
Press {Save}.
5
Press {OFF} to exit programming mode.
Direct commands chart
Feature
Ringer volume
Ringer tone
Voice enhancer
Dial lock
LCD contrast
Key tone
Auto talk
Set area code
Set dial mode
Set recall time
Set line mode
Handset registration
Note:
L If you make a mistake or enter the wrong code, press {OFF} then start again by
pressing {MENU}.
Feature code
Setting code
{1}: Low {2}: Medium
{1} {1}
{3}: High {0}: Off
{1}–{3}: Tone pattern 1–3
{1} {2}
{4}–{7}: Melody pattern 1–4
{1}: On {0}: Off
{5}
Go to step 3 on page 31.
{6}
{1}–{6}: Level 1–6
{0} {1}
{1}: On {0}: Off
{0} {2}
{1}: On {0}: Off
{0} {3}
Go to step 4 on page 30
{0} {4}
{0} {5} {1}
{1}: 700 ms {2}: 600 ms
{0} {5} {2}
{3}: 400 ms {4}: 300 ms
{5}: 250 ms {6}: 110 ms
{7}: 100 ms {8}: 90 ms
{1}: A {2}: B
{0} {5} {3}
Go to step 4 on page 32.
{0} {0}
Programmable Settings
–
Page
page 28
page 28
page 29
page 31
page 29
page 31
page 29
page 30
page 38
page 30
page 30
page 31
33