TG5431_5432_5433_QG(e).fm Page 6 Monday, November 8, 2004 9:07 PM
Programming via direct commands
You can program most features using "direct commands"—special codes that take you
directly to the feature you wish to program and allow you to select the desired setting.
There is no need to scroll through the unit's menus.
1
Press {MENU}.
2
Enter the desired feature code (shown below).
3
Enter the desired setting code (shown below).
4
Press {Save}.
5
Press {OFF} to exit programming mode.
Direct commands chart
Feature
Ringer volume
Ringer tone
Voice enhancer
LCD contrast
Auto talk
Set dial mode
Ring count
Recording time
Change language
Message alert
Feature code
Setting code
{1}: Low {2}: Medium
{1} {1}
{3}: High {0}: Off
{1}–{3}: Tone pattern 1–3
{1} {2}
{4}–{7}: Melody pattern 1–4
{1}: On {0}: Off
{5}
{1}–{6}: Level 1–6
{0} {1}
{1}: On {0}: Off
{0} {3}
{1}: Pulse {2}: Tone
{0} {5} {1}
{2}–{7}: 2–7 rings
{0} {6} {1}
{0}: Toll saver
{1}: 1 minute
{0} {6} {2}
{2}: 2 minutes
{3}: 3 minutes
{0}: Greeting only
{1}: English {2}: Spanish
{0} {8}
{1}: On {0}: Off
{0} {#}
–
–
6