Miscellaneous (Others) Set Mode; Monitor; Monitor Level; Beep (Confirmation) - Icom IC-7000 Instruction Manual

1 Monitor

This item sets the TX monitor function ON or OFF.
The monitor gain can be set described below.

2 Monitor Level

This item adjusts the transmit IF signal monitor level
See page 87 for details.
3 Beep(Confirmation)
A beep sounds each time a switch is pushed to con-
firm it. This function can be turned OFF for silent op-
eration.
The volume level can be set described below.

4 Beep(Band Edge)

A beep sounds when an operating frequency enters
or exits an amateur band. This functions independent
of the confirmation beep setting (above).
The volume level can be set described below.

5 Beep Level

This item adjusts the volume level for (confirmation
steps. When beep tones are turned OFF, this setting
has no effect.

6 Beep Level Limit

This item allows you to set a maximum volume level
for (confirmation and band edge) beep tones. The
beep tones are linked to the [AF] control until a
specified volume level is reached — further rotation
of the [AF] control will not increase the volume of the
beep tones.
ON
T X m o n i t o r f u n c t i o n i s
turned ON.
ON
Confirmation beep ON
(default)
ON
Band edge beep ON
(default)
ON
Beep level is limited with
[AF] (default)
13
SET MODE
OFF
T X m o n i t o r f u n c t i o n i s
turned OFF. (default)
5 0 %
OFF
Confirmation beep OFF
OFF
Band edge beep OFF
5 0 %
OFF
linked
Beep level is to [AF]
13
128