Basic Start-Up Operations - Panasonic KX-TCD705NL Operating Instructions Manual

30678_KX-TCD705 Dutch_a_English

Basic Start-up Operations

Note: Z shows that you should press the following key(s).
Turning the Power On
1. Z and hold P
• A confirmation tone sounds.
• All possible configurations briefly appear.
• When button is released, the display will change to the standby mode.
The current connected base unit number is displayed
• You can choose whether to display the base unit number, handset number or no
display in the standby mode (see page 38).
The number of New Caller ID calls received are displayed.
Making a Call
(For further information on making calls, see pages 13-16)
1. Z O or %.
2. Dial a phone number (maximum 24 digits)
The dialled number is displayed.
(If a number is entered incorrectly, Z P).
After a few seconds, the display will start showing the length of the call.
Terminating a Call
1. To hang up, Z P.
• After a few seconds, the display returns to the standby mode.
• If the handset is placed on the base or charger during a call, the call is
disconnected.
• The dialled number is stored in the redial memory.
Answering a Call
(For further information on answering calls, see page 17.)
During Incoming call:
1. Z O
• You can also answer a call by pressing any dialling button K to I, $, L
or N (-Any Key Answer).
Or Z % and when the other party answers, talk into the microphone.
After a few seconds, the display will start showing the length of the call.
Turning the Power Off
Make sure that the unit is in the standby mode.
1. Z and hold P until a long beep sounds.
• The display will go blank. (On location of the handset in the base unit, the battery
icon will display even after power off).
22/6/01 9:22 am Page 12
12
Base 1
10 New Calls
Î Ï  Ô Í Á Ò