Table of Contents
Advertisement
700al
australian 2 5 02
Basic Start-up Operations
Turning the Power On
1. Z and hold P
• After all characters briefly appear, the display will change to
the standby mode when the button is released. A
confirmation tone sounds.
• The current connected base unit number is displayed (–1–)
• The number of New Caller ID calls received are displayed (eg. 02)
• You can choose whether to display the base unit number, handset number,
clock or no display in the standby mode (see p.33).
Making a Call
For further information on making calls, see pages 15-16.
1. Z O
2. Dial a phone number
The dialled number is displayed.
(If a number is entered incorrectly, Z P).
After a few seconds, the display will start showing the length of the call.
Terminating a Call
1. To hang up, Z P.
• The handset will return to the standby mode.
• The dialled number is stored in the redial memory.
Answering a Call
(For further information on answering calls, see page 17).
1. Z O
• You can also answer a call by pressing any dialling button
K to I, J or L (-Any Key Answer).
After a few seconds, the display will start showing the length of the call.
Turning the Power Off
Make sure that the unit is in the standby mode.
1. Z and hold P until a beep sounds
• The display will go blank.
(On location of the handset in base unit, the battery icon will display even after
power off).
2/5/02
3:00 pm
Page 14
14
-1-œœœœœœœ02
Î
Ò
Advertisement
Table of Contents
