HP Apollo 4200 Gen9 User Manual page 70

Secure the cable in the rear drive cage cable clip.
c.
Close the cable management holder (on page 34).
d.
Depending on which storage controller you prefer to use for managing the rear drives, perform one
19.
of the succeeding storage cabling option procedures.
Connect the preinstalled Mini-SAS x4 cable (on page 70).
o
Connect the Mini-SAS x4 cable marked as MLB (on page 71).
o
Install the H240 HBA and its Mini-SAS x4 cables (on page 72).
o
Install the P440 controller and its Mini-SAS Y-cable (on page 74).
o
Install the air baffle (on page 32).
20.
Install the access panel (on page 30).
21.
Install the server into the rack (on page 45).
22.
Hewlett Packard Enterprise recommends installing at least one drive in the rear drive cage
23.
cage options" on page 58).
Populate drive bays based on the drive numbering sequence. Start from the drive bay with the
lowest device number.
Power up the server (on page 19).
24.
Connect the preinstalled Mini-SAS x4 cable
In this storage cabling option, the rear SFF drives 49-52 are managed by the Flexible Smart Array P840ar
Controller, while drives 53-54 are managed by the onboard Dynamic Smart Array B140i Controller. Both
the multiconnector drive signal cable and the preinstalled Mini-SAS x4 cable from the front drive cage 2
backplane will be in use.
Release the preinstalled Mini-SAS x4 cable from the system board cable clips.
1.
Remove the plastic cover from the released Mini-SAS x4 cable.
2.
("Drive
Hardware options installation 70