Remove The Server From The Rack - HP Apollo 4200 Gen9 User Manual

Remove the power input module.
d.

Remove the server from the rack

WARNING: To reduce the risk of personal injury from hot surfaces, allow the drives, power
input modules, and the internal system components to cool before touching them.
WARNING: This server is very heavy. To reduce the risk of personal injury or damage to the
equipment:
• Observe local occupational health and safety requirements and guidelines for manual
handling.
• Reduce the weight of the server by removing the drives and power input modules before
installing or removing the server from the rack.
• Obtain adequate assistance to lift and stabilize the server during installation or removal.
Hewlett Packard Enterprise recommends that a minimum of two people are required for
installing or removing the server from the rack. A third person might be required to help
align the server if the server is installed higher than chest level.
• Use caution when installing or removing the server from the rack; it is unstable when not
fastened to the rails.
To remove the server from a Hewlett Packard Enterprise, Compaq-branded, Telco, or a third-party rack:
Back up all server data.
1.
Power down the server (on page 19).
2.
Remove all power:
3.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
Disconnect all peripheral cables from the server.
4.
Remove all installed power input modules.
5.
If a rear drive cage option is installed, remove all rear drives
6.
cage" on page 23).
Remove all the drives installed in the front drive cages 1 and 2
7.
cages" on page 22).
Remove the server from the rack:
8.
Loosen the rack ear thumbscrews.
a.
("Remove a drive from the rear drive
("Remove a drive from the front drive
Operations 28