HP Apollo 4200 Gen9 User Manual page 69

Secure the cable in the rear drive cage cable clip.
13.
Do one of the following:
14.
Install the FlexibleLOM blank.
a.
If removed, install the FlexibleLOM adapter.
b.
Connect the common 5x2 connector of the power Y-cable to the system board.
15.
Connect the smaller 5x2 connector of the power Y-cable to the drive backplane.
16.
Secure the cable in the rear drive cage cable clip.
17.
If you are NOT installing an H240 HBA or a P440 controller for the six-bay SFF rear drive cage,
18.
connect the multiconnector drive signal cable:
Connect the common end of the multiconnector drive signal cable to port 2 of the rear drive
a.
backplane.
Connect the split ends of the multiconnector drive signal cable to the system board.
b.
Hardware options installation 69