Troubleshooting - ProForm G880 PFEVBE4805.0 User Manual

44. Attach the Low Cable (82) inside the Rear Base
(33) with an M10 x 75mm Bolt (127), two M10
Washers (99), two 27mm Spacers (87), and an
M10 Nylon Locknut (97). Do not overtighten the
Locknut; the Cable must be able to pivot easily.
45. Attach the Butterfly Backrest (80) to the Center
Upright (37) with two M6 x 72mm Screws (105)
and two M6 Washers (101).
46. Make sure that all parts have been properly tightened. The use of the remaining parts will be explained in
ADJUSTMENTS, beginning on the following page.
Before using the weight bench, pull each cable a few times to make sure that the cables move smoothly
over the pulleys. If one of the cables does not move smoothly, find and correct the problem. IMPORTANT: If
the cables are not properly installed, they may be damaged when heavy weight is used. See the
CABLE DIAGRAMS on page 22 of this manual for proper cable routing. If there is any slack in the
cables, you will need to remove it by tightening the cables. See TROUBLESHOOTING on page 23.
44
97
99
87 33
82
127
87
99
45
37
105
80
101
101
105
18
19. Press a Round Joint Bushing (74) into the Left
Frame Joint (49).
Orient the Top Frame (40) with the name decal in
the indicated position. Attach the Top Frame to
the Left Frame Joint (49) with two M10 x 91mm
Bolts (116), four M10 Washers (99), and two M10
Nylon Locknuts (97). Do not tighten the
Locknuts yet.
Assemble the Right Frame Joint (50) to the
Top Frame (40) in the same manner.
20. Attach the Left Frame Joint (49) to the Left
Upright (36) with two M10 x 91mm Bolts (116),
four M10 Washers (99), and two M10 Nylon
Locknuts (97). Do not tighten the Locknuts yet.
Attach the Left Frame Joint (49) to the Guide Bar
(41) with an M10 x 50mm Screw (108) and an
M10 Washer (99).
Assemble the Right Frame Joint (50) in the
same manner.
21. Slide the Weight Bar (55) through the Left Barbell
Glider (51), the Locking Bar (56), and the Right
Barbell Glider (123). Make sure the Locking Bar
is oriented as shown.
Engage the hooks on the Locking Bar (56) into a
set of holes in the Uprights (36, 69).
22. Slide a Weight Stop (67) onto the Weight Bar
(55). Thread a 1/4" x 14mm Screw (119) into the
Weight Stop and the hole in the Weight Bar. Do
not tighten the Screws.
Thread a 1/4" x 14mm Screw (119) into the Left
Barbell Glider (51). Do not tighten the Screws.
Repeat this step with the Right Barbell Glider
(not shown) and the other Weight Stop (not
shown).
19
40
50 Decal
99
99
116
74
20
108
99
49
41
97
99
99
36
116
21
69
123 56
51
22
55
67
51
119
119
11
97
49
36
55