Status Leds - Nortel 2330 Installation Manual

Note.
The solid surface mounting option requires Cat-5 cable that does not have strain
relief. The other mounting options can use Cat-5 cable with or without strain relief.

Status LEDs

The AP has LEDs that provide status information of the device.
describes the LEDs.
Figure 4. Health and Radio LEDs—AP-2330/2330A/2330B
Table 1: Access Point LEDs—AP-2330/2330A/2330B
LED Appearance
Health Solid green
Solid amber
Alternating green and
amber
Radio 2 LED
Health LED
Meaning
All the following are true:
•
•
•
•
AP is waiting to receive boot instructions and a
configuration file from a WSS.
AP is booting and receiving its configuration file from a
WSS.
Nortel WLAN Access Point 2330/2330A/2330B Installation Guide
Figure 4 shows the locations of the LEDs.
Radio 1 LED
Management link with a WSS is operational.
AP has booted.
AP has received a valid configuration from a WSS.
At least one radio is enabled or is in sentry mode.
AP overview 31
Table 1