Nortel 2330 Installation Manual page 54

54 Installing and connecting an AP-2330/2330A/2330B
5
As shown in
connector opening and align the universal mounting bracket over the drywall anchors so that the two
screw holes in the bracket face the drywall anchors.
6
Insert the #6 sheet metal screws into the screw holes, and tighten them to secure the universal mounting
bracket to the wall or ceiling.
(If you routed the Cat-5 cable (ferrite beaded for AP-2330) through a hole in the wall or ceiling, insert the
screw into the center screw hole only.)
Note.
are the holes indicated by the dashed lines in
holes. They are not screw holes.
Figure 29. Steps 5 and 6—Bracket Placement on Solid Wall or Ceiling
7
As shown in
NN47250-302 (320661-E Version 02.01)
Figure 29 on page 54, feed the Cat-5 cable (ferrite beaded for AP-2330) through the port
Do not insert screws in the four holes on the edges of the bracket. (These
Figure 30, insert the Cat-5 cable (ferrite beaded for AP-2330) into the connector:
Figure 29.) The AP fits into these