Operation Chart; Common Features And Usage; Basic Operation; Full Size - Panasonic DP-6010 Operating Instructions Manual

Operation Chart

Common Features and Usage

I I I I I

Basic Operation

Original
Turn the Power
Switch On
I I I I I
Position of the Original
From i-ADF
Original Guides
Adjust to the original's width
I I I I I
Commonly Used Functions and Operating Procedures
I I I I I
Memory Capacity
If the memory becomes full during original scanning, the message "Cannot Complete / Job
Exceeds Memory Capacity" will be displayed on the LCD. If this occurs, follow the instructions
on the LCD.
When additional memory is required, consult with an authorised servicing dealer.
NOTE
4
Turn the main
Power Switch On
(Located on the
back of the
Copier)
1
Load Paper
Place the Original(s)
(Up to 70/i-ADF)
From Platen
i-ADF Tray

Full Size

Makes a copy that is the same
size as the original
Reduction or Enlargement
Copies the original at a fixed
reduction or enlargement ratio
C If the fusing temperature drops excessively on the DP-4510/6010 during a multi-copy
cycle, there is a remote possibility that the copying speed will be reduced. The copying
speed will automatically return to normal when the fusing temperature rises enough to
ensure good fusing performance.
B4·FLS
2 3
Press the COPY SIZE
COPY Key (Reduction/
Enlargement Only)
Original Guide
C Place originals face down on the
platen or face up on the i-ADF.
C If the original is not positioned
properly, a portion of the original
may not be copied.
C For originals smaller than A5 size,
position the original within the A5
area and select A5.
1 2 4 5
1 2 3 4
4 5
Number Press
of Copies START
(See page 16)
5
(See page 18)