Operation Chart; Quick Operation Chart; Adding Paper - Panasonic Workio DP-1520P Operating Instructions Manual

Getting To Know Your Machine

Operation Chart

■ Quick Operation Chart

Turn the Power

Adding Paper

Switch to the
ON position
● Adding Paper (Paper Tray)
The following steps are for Paper Tray-1, use the same procedures for other optional Paper Trays.
1
Paper Tray
NOTE:
When changing the paper size,
refer to page 54.
● Adding Paper (Sheet Bypass)
Copying on Special Paper, etc.
1
PUSH
Sheet Bypass
4
Width Guides
14
1
From
ADF/i-ADF
(Option)
Original Guides ∗ ∗ ∗ ∗ ∗
Adjust to the
or
original's width
∗ ∗ ∗ ∗ ∗
Hold the guides by the center when
adjusting the width
Original Guides
From
Platen
2
Max Level
Indicator
Load Paper: Face Up
Paper Weight: 60 - 90 g/m
Paper Capacity: 550 Sheets (80 g/m
2
Until it stops
Adjust the width guides.
Incorrect adjustment may cause the
paper to wrinkle, misfed or skew.
2
Face Up
Tray
(Max. 50 A4
size originals)
Face Down
● If the original is not positioned
properly, a portion of the original
may not be copied.
● For originals smaller than A5
size, position the original within
the A5 area and select A5.
3
NOTE:
2
Make sure that the paper is set
2
)
properly and that it does not exceed
the Max. Level indicator.
3
Face Down
Upper Limit Guides
Load Paper
(Do not exceed limit guides)
Paper Weight: 55 - 133 g/m
Paper Capacity: 50 sheets/80 g/m
To add paper to the Sheet Bypass,
remove the leftover paper from the
tray, and align it with the additional
paper and load them together onto the
tray.
If set in other
function mode
Paper Tray
4
Until it stops
2
2