Table of Contents
Advertisement
Installation
The proper order of steps must be followed to ensure correct in-
stallation. Refer to the list below when installing your unit.
1. Position unit near area of installation.
2. Remove the shipping materials.
3. Connect the fill hoses.
4. Connect the drain hose to the drain receptacle.
5. For gas models only, connect the gas supply pipe. Check for
gas leaks.
6. For electric models only, connect the electrical cord.
7. Connect dryer to exhaust system.
8. Position and level the unit.
9. Wipe out inside of washer and dryer drums.
10. Plug in the washer and dryer.
11. Check installation.
12. Start and run the dryer in a heat setting to verify dryer is heat-
ing.
Position Unit Near Installation Area
Move unit so that it is within 4 feet [1.2 meters] of the desired
area of installation.
Washer and dryer are not designed to be operated as
separated, side-by-side units.
The stack washer/dryer must be installed on a ground or base-
ment floor, preferably concrete. If the flooring is wood construc-
tion, the flooring must meet a static load rating of 125 pounds
and a maximum dynamic load rating of 170 pounds per foot. If
the existing floor does not meet the dynamic load rating, the floor
must be re-enforced from below to meet the specification (maxi-
mum span = 16 feet, 2x10 joists, 16 inches on center, 1 inch sub
floor).
The stack washer/dryer must be installed on a smooth, non-slip
surface. Un-level tile and extremely slippery surfaces should be
avoided. Do not install the washer on carpeting, soft tile or other
weakly supported structures.
Failure to meet the minimum floor load and surface requirements
or installing the products on above ground floors can create dif-
ferent levels of vibration or movement that may appear like serv-
ice is required. Speed Queen will not cover scheduled repair serv-
ices where the installation requirements are not per specifica-
tions, nor can products be returned to the authorized dealer in
these cases.
Remove Shipping Materials
10
CAUTION
©
Copyright, Alliance Laundry Systems LLC - DO NOT COPY or TRANSMIT
1. Remove two screws at bottom of front access panel. Rotate
bottom of panel out and remove panel.
2. Remove two 9/16 inch bolts and washers holding shipping
brace to weight.
3. Remove two 9/16 inch bolts and washers holding shipping
brace to washer base and remove brace.
W187
4. Go to rear of washer and pull label from rear shipping bolts.
5. Remove two 9/16 inch bolts. Unscrew each bolt while apply-
ing forward pressure just until bolt stops unthreading. Work
each bolt and spacer out by hand using a circular motion.
NOTE: Avoid backing bolts out completely or
spacers might fall into cabinet.
FLW2378N_SVG
Figure 2
FLW2296N_SVG1
Figure 3
Part No. 804671R2
Hide quick links:
Advertisement
Table of Contents
