Table of Contents
Advertisement
WARNING
Units elevated above floor level must be anchored to
that elevated surface, base or platform. The material
used to elevate the unit should also be anchored to
the floor to ensure that the unit will not walk or that
the unit can not be physically pulled, tipped or slid
from its installed position. Failure to do so may re-
sult in conditions which can produce serious injury,
death and/or property damage.
1. Position unit so it has sufficient clearance for installation and
servicing.
A
B
NOTE: Shaded areas indicate adjacent structure.
Dryer and Exhaust Duct Clearances
Area
A
Left Dryer Side
B
Right Dryer Side 1 in. [25 mm]
C
Dryer Top
D *
Dryer Rear
E
Exhaust Duct
Clearance to
Combustible Ma-
terials
Part No. 804671R2
C
D
SWD1006N_SVG
Minimum
Description
Clearance
0 in. [0 mm]
6 in. [152 mm]
4 in. [102 mm]
2 in. [51 mm]
©
Copyright, Alliance Laundry Systems LLC - DO NOT COPY or TRANSMIT
Dryer and Exhaust Duct Clearances
Area
* Rear clearance is minimum. 6 inches [152 mm] are
recommended when venting through rear of unit.
NOTE: Use of the dispenser drawer or unit doors as
a handle in the transportation of the unit may cause
damage to the dispenser or doors.
2. Place unit in position on a solid, sturdy and level floor. Instal-
W307
ling the unit on any type of carpeting, soft tile or other weakly
supported structures is not recommended.
3. Place a level on the raised portion of cabinet top and check if
the unit is level from side to side and front to back.
4. If unit is not level, tilt unit to access the front and rear level-
ing legs. For easier access to leveling legs, prop up unit with a
wooden block.
5. Loosen 7/8 in. locknut and adjust legs by screwing into or out
E
of unit base until the unit is level from side to side and front
E
to back (using a level). Unit should not rock.
NOTE: Leveling legs can also be adjusted from in-
side the unit using an adjustable wrench.
6. Tighten the locknuts securely against the unit base. If the
locknuts are not tight, unit will move out of position during
operation.
NOTE: DO NOT slide unit across floor if the leveling
legs have been extended. Legs and base could be-
come damaged.
7. Remove rubber feet from accessories bag and place on all
four leveling legs.
8. Verify that unit doesn't rock.
Installation
Minimum
Description
Clearance
21
Hide quick links:
Advertisement
Table of Contents
