Table of Contents
Advertisement
Installation
Electric Dryers
1. Close the loading door and start the dryer in a heat setting (re-
fer to the operation instructions).
2. After the dryer has operated for three minutes, the exhaust air
or exhaust pipe should be warm.
Gas Dryers
IMPORTANT: This operation is to be conducted by
qualified personnel only.
1. To view the burner flame, remove the lower front panel of the
dryer.
2. Close the loading door and start the dryer in a heat setting (re-
fer to the operation instructions). The dryer will start, the ig-
niter will glow red and the main burner will ignite.
IMPORTANT: If all air is not purged out of gas line,
gas igniter may go off before gas is ignited. If this
happens, after approximately two minutes igniter
will again attempt gas ignition.
IMPORTANT: If igniter does not light, make sure gas
is turned on.
3. After the dryer has operated for approximately five minutes,
observe burner flame through lower front panel.
4. Adjust the air shutter to obtain a soft, uniform blue flame. (A
lazy, yellow-tipped flame indicates lack of air. A harsh, roar-
ing, very blue flame indicates too much air.) Adjust the air
shutter as follows:
a. Loosen the air shutter lockscrew.
b. Turn the air shutter to the left to get a luminous yellow-
tipped flame, then turn it back slowly to the right to obtain
a steady, soft blue flame.
c. After the air shutter is adjusted for proper flame, tighten
the air shutter lockscrew securely.
5. Reinstall the lower front panel.
To reduce the risk of serious injury or death, low-
er front panel must be in place during normal op-
eration.
6. After the dryer has operated for approximately three minutes,
exhaust air or exhaust pipe should be warm.
26
WARNING
©
Copyright, Alliance Laundry Systems LLC - DO NOT COPY or TRANSMIT
4
1. Air Shutter Lockscrew
2. Air Shutter
3. Appliance Main Gas Valve
4. 1/8 in. [3.1 mm] Pipe Plug (For checking manifold pres-
sure)
W158
1
2
3
D702I_SVG
Figure 28
Part No. 804671R2
Hide quick links:
Advertisement
Table of Contents
