Cleaning The Rgb Panels - Sanyo PLV-Z4 Service Manual

Hide thumbs Also See for PLV-Z4:
Table of Contents

Advertisement

Cleaning the RGB panels

Blemishes such as dust and dirt on the internal optical components of the projector tend to degrade the
brightness of the screen and are likely to appear as a shadow on the screen, which can lead to deterioration of
image quality.
This projector is equipped with the RGB panel cleaning holes on the bottom for cleaning of the internal parts
(such as optical components) of the projector. When you use the projector for a lengthy period of time or a
shadow of dust appears on the projected screen, clean the inside of the projector.
Using the supplied air blower and with the Cleaning function in the Setting Menu, you can remove the dusts from
the projector.
Note:
• Dust might not be removed completely with these steps. In that case, contact the dealer where you pur-
chased the projector or service center.
CAUTION IN USING THE AIR BLOWER AND THE NOZZLE
● Turn the projector over when using the blower.
● Use only the supplied air blower and nozzle to keep the projector from being out of oder or
CAUTION
damaged. We could not guarantee the malfunction or breakage caused by other tools.
● Never use a commercially available compressed air duster. It causes the interior of the projector to
malfunction with release of cold liquid propellant.
● Put the projector on a soft cloth to prevent scratching the surface.
● Open the hole cover only when you clean the inside of the projector.
PROHIBITED
● Do not look into the holes. A strong light could damage your eyes. (Do not look into the Air intake
vent and Exhaust vent, either.)
● Use the blower and nozzle only to clean the projector. Do not attempt to use them for other
purposes. Do not use the blower and nozzle against persons (particularly to eyes, mouth or ear, and
so on). Be especially careful to ensure that children do not put the blower and nozzle into their
mouth and swallow them.
● Do not attempt to pull the nozzle out of the blower. If the nozzle happened to be pulled out, put it
back into the blower immediately.
● Do not use the blower supplied with this projector (Z4) to clean the Z3 and Z1X.
(Nozzle colour : this projector (Z4) - - light blue, Z3 and Z1X - - red)
In the unlikely event that something goes wrong (smoke, a strange sound, an abnormal odor, and such) while you
are cleaning, turn off and unplug the projector immediately, then call the dealer where you purchased the
projector or service center.
If the nozzle is pulled out ....
The nozzle has the stopper. Put the stopper-side of the nozzle into
the blower. Put the nozzle firmly into the blower until the stopper
becomes invisible.
When putting the nozzle into the blower, hold near the stopper so
that it will not break.
Make sure not to attempt to pull the nozzle out of the blower.
Hold near the stopper
of the nozzle.
- 8 -
Put this end of the
nozzle into the
blower.
Put the nozzle in
until the stopper
becomes invisible.
Stopper

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents