Network Setting; Troubleshooting - Epson TM-T70-i User Manual

Network Setting

Make the same settings on the computer and access points as those printed in the status sheet.
Use the web browser to make the network settings. Input the printer's IP address in an address bar
of the web browser, and make the network settings as directed in TM-T70-i Technical Reference
Guide.
Initializing the Network Setting
To reset the network settings to the default values, press the push button at the interface
part (shown in the following illustration) for more than 10 seconds. When you release the
button, the initialization will be started.

Troubleshooting

No lights on the control panel
Check whether the printer is correctly connected to a power source. (See "Connecting to a
Power Source" on page 4.)
ERROR LED on (not flashing) with no printing
❏
Check whether the roll paper cover is closed. If it is open, close it.
❏
If PAPER OUT LED is on, check whether the roll paper is correctly installed and any
roll paper remains.
ERROR LED flashing with no printing (and no paper jam)
Printing stops if the thermal head overheats and resumes automatically when it cools.
For other cases, turn the printer off, and after 10 seconds, turn it back on.
No connection to external devices
When the status LED (shown in the illustration on page -7) is lit in green
❏
Check whether the interface cable or the wireless LAN cable set (optional product) is
connected correctly. (See "Connecting to External Devices" on page 5.)
❏
Print the status sheet to check whether the network settings are correct. (See
"Confirming the Network Settings" on page 6.)
When the status LED (shown in the illustration on page -7) is off / lit in orange
When the status LED is off after turning on the printer or remains lit in orange even if 30
seconds have passed after turning on the printer, the interface board needs repairing.
Status LED
Orange: Booting
Green: Operating normally
Push button
TM-T70-i User's Manual 7