Telephone Wall Mounting
This section explains how to mount digital and electronic telephones to a wall or other vertical
surface. See the manufacturer's documentation for instructions on mounting standard phones.
Notes
Digital telephones equipped with PDIU-DIs, RPCI-DIs or PDIU-DI2s cannot be wall
G
mounted.
Electronic and older digital telephones equipped with an HHEU1 can be wall mounted. 2000-
G
series digital telephones with headsets can only be wall mounted with an HHEU2.
➤ To mount digital and electronic telephones
Refer to
Figures 11-7~11-8
1. Loosen the captive screws, and remove the
telephone base.
2. Using a suitable cutter, remove the handset
hanger from the base.
3. Insert the handset hanger in the slot on the front
of the phone. The hanger fits in the notch on the
handset cradle.
4. Rotate the telephone base 180 degrees and
secure it to the telephone with its four captive
screws.
5. Connect the phone to the wall modular
connector with a cord approximately four
inches long (available at most telephone supply
companies).
6. Route the cord into the hollow portion of the
base.
7. Mount the phone on the wall mounting modular
connector plate.
1479
Figure 11-9
Handset
Strata DK I&M
6/00
and the following steps.
Handset
Hanger
Handset Hanger
1478
Figure 11-7
Removing the Telephone
1480
Figure 11-8
Wall Mounting Base Rotation
Station Apparatus
Dip Switches
Plastic Tab
11-11