Installing An Internal Solutions Port - Dell S5830DN User Manual

Additional printer setup

Installing an Internal Solutions Port

The controller board supports one optional Internal Solutions Port (ISP).
Note: This task requires a flat‑head screwdriver.
CAUTION—SHOCK HAZARD: If you are accessing the controller board or installing optional hardware
or memory devices sometime after setting up the printer, then turn the printer off, and unplug the power
cord from the electrical outlet before continuing. If you have any other devices attached to the printer,
then turn them off as well, and unplug any cables going into the printer.
Warning—Potential Damage: Controller board electronic components are easily damaged by static
electricity. Touch something metal on the printer first before touching any controller board electronic
components or connectors.
1
Access the controller board.
For more information, see
2
If an optional printer hard disk is installed, then remove the printer hard disk first.
For more information, see
3
Unpack the ISP kit.
1
2
3
4
"Accessing the controller board" on page
"Removing a printer hard disk" on page
ISP solution
Screw for attaching the plastic bracket to the ISP
Screws for attaching the ISP mounting bracket to the controller board shield
Plastic bracket
21.
35.
26