Additional Printer Setup; Installing Internal Options - Dell S5830DN User Manual

Additional printer setup

Additional printer setup

Installing internal options

CAUTION—SHOCK HAZARD: If you are accessing the controller board or installing optional hardware
or memory devices sometime after setting up the printer, then turn the printer off, and then unplug the
power cord from the electrical outlet before continuing. If you have any other devices attached to the
printer, then turn them off as well, and unplug any cables going into the printer.
Available internal options
Note: Some options are available only in select printer models. For more information, contact the place
where you purchased your printer.
•
Memory card
–
DDR3 DIMM
–
Flash memory
•
Fonts
•
Firmware cards
–
Forms and Bar Code
–
PRESCRIBE
–
IPDS
•
Printer hard disk
•
Internal Solutions Ports (ISP)
Accessing the controller board
Note: This task requires a flat‑head screwdriver.
CAUTION—SHOCK HAZARD: If you are accessing the controller board or installing optional hardware
or memory devices sometime after setting up the printer, then turn the printer off, and unplug the power
cord from the electrical outlet before continuing. If you have any other devices attached to the printer,
then turn them off as well, and unplug any cables going into the printer.
1
Remove the controller board access cover.
21