Smtp Setup Menu - Dell S5830DN User Manual

Understanding printer menus
Use
Honor DSR
On
Off

SMTP Setup menu

Use
Primary SMTP Gateway
Primary SMTP Gateway Port
Secondary SMTP Gateway
Secondary SMTP Gateway Port
SMTP Timeout
5–30
Reply Address
Use SSL
Disabled
Negotiate
Required
SMTP Server Authentication
No authentication required
Login/Plain
CRAM‑MD5
Digest‑MD5
NTLM
Kerberos 5
To
Determine whether the printer uses the DSR Signal.
Notes:
•
Off is the factory default setting.
•
DSR is a handshaking signal used by most serial cables. The serial port
uses DSR to distinguish data sent by the computer from data created by
electrical noise in the serial cable. The electrical noise can cause stray
characters to print. Set this to On to prevent stray characters from
printing.
To
Specify SMTP server gateway and port information.
Note: 25 is the default SMTP gateway port.
Specify the amount of time in seconds before the server stops trying
to send an e‑mail.
Note: 30 is the factory default setting.
Specify a reply address of up to 128 characters in the e-mail sent by
the printer.
Set the printer to use SSL for increased security when connecting to
the SMTP server.
Notes:
•
Disabled is the factory default setting.
•
When the Negotiate setting is used, the SMTP server
determines if SSL will be used.
Specify the type of user authentication required for printing
privileges.
Note: "No authentication required" is the factory default setting.
107