Front Panel Display Code Information For Battery Charger - Miller TRAILBLAZER 302 AIR PAK Owner's Manual

.
A complete Parts List is available at www.MillerWelds.com

12-2. Front Panel Display Code Information For Battery Charger

Right
Left Display
Display
JUMP CHRG
CHRG 10 − 75
JUMP 10 − 75
24V JUMP
24V CHG
12V JUMP
12V CHG
CHK BATT
OM-229 930 Page 56
Description
DC/Battery/AC Switch in Jump/
Charge position
DC/Battery/AC Switch in Jump/
Charge position
DC/Battery/AC Switch in Jump/
Charge position
DC/Battery/AC Switch NOT in
Jump/Charge position
DC/Battery/AC Switch NOT in
Jump/Charge position
DC/Battery/AC Switch NOT in
Jump/Charge position
DC/Battery/AC Switch NOT in
Jump/Charge position
DC/Battery/AC Switch in
Jump/Charge position
How/When Code Is Displayed
Code is displayed when Air Compressor switch is not in a battery charge or
jump position.
Code is displayed when Air Compressor switch is in a battery charge posi-
tion. 10 − 75 displays preset maximum charge current set by V/A control.
Code is displayed when Air Compressor switch is in a jump position. 10 −
75 displays preset maximum charge current set by V/A control.
Code is displayed when Air Compressor switch is in 24 volt jump position.
Code is displayed when Air Compressor switch is in 24 volt charge posi-
tion.
Code is displayed when Air Compressor switch is in 12 volt jump position.
Code is displayed when Air Compressor switch is in 12 volt charge posi-
tion.
Charger is detecting a fault in the set up or the battery:
Wrong voltage battery (set up for 12 volt and connect a 24 volt battery or
set up for 24 volt and connect a 12 volt battery)
Bad connection (no battery detected)
Battery is not accepting a charge (open battery cell[s]).
In JUMP 24 volt mode, charger will cycle three times when a battery is not
accepting a charge and then provide current for jump starting. In JUMP 12
volt mode the charger will go directly to providing current for Jump Starting.