Connecting Installed Battery To Battery Charge Receptacle - Miller TRAILBLAZER 302 AIR PAK Owner's Manual

8-3. Connecting Installed Battery To Battery Charge Receptacle

Battery located in vehicle
(Negative post grounded to chassis)
.
See information below regarding vehicles
with battery Positive (+) grounded to chassis.
1
2
!
Stop welding generator engine.
Place Air Compressor switch in the
Off position.
!
Before charging battery, check po-
larity of battery posts. If battery Neg-
ative (−) post is grounded to chassis
(most vehicles), connect charger
Positive (+) cable to Positive (+) un-
grounded post of battery. Connect
charger Negative (−) cable to vehicle
engine block or heavy gauge metal
part of frame (and away from bat-
tery). If Positive (+) post is grounded
to chassis, connect charger Negat-
ive (−) cable to Negative (−) un-
grounded post of battery. Connect
charger Positive (+) cable to vehicle
chassis or engine block (and away
from battery).
3
+
−
4
.
Connect black (Negative) char-
ging cable to chassis or engine
block (and away from battery).
1 Battery Positive (+) Terminal
2 Battery Negative (−) Terminal
Obtain Battery Charge/Jumper Cable Kit
300 422 or equivalent.
3 Red (Positive) Charging Cable
4 Black (Negative) Charging Cable
5 Battery Charge Plug
6 Battery Charge Receptacle
7 Insulated Battery Cable
(Customer-Supplied)
If battery Negative (−) post is grounded to
chassis, connect red (Positive) battery
.
A complete Parts List is available at www.MillerWelds.com
5
charging cable to battery Positive (+) post.
Connect black (Negative) battery charging
cable to engine block or heavy gauge metal
part of frame (and away from battery)
If battery Positive (+) post is grounded to
chassis, connect black (Negative) battery
charging cable to battery ungrounded Neg-
ative (−) post. Connect red (Positive) bat-
tery charging cable to engine block or
heavy gauge metal part of frame (and away
from battery).
Connect Battery Charge plug to Battery
Charge receptacle.
6
OM-229 930 Page 41