Weld Output Terminals; Connecting To Weld Output Terminals - Miller TRAILBLAZER 302 AIR PAK Owner's Manual

.
A complete Parts List is available at www.MillerWelds.com

5-8. Weld Output Terminals

1

5-9. Connecting To Weld Output Terminals

1
6
3
4
5
OM-229 930 Page 28
2
Tools Needed:
3/4 in.
!
Stop engine.
!
Do not connect to CC and CV
terminals at the same time.
1 Work Weld Output Terminal
2 Stick/TIG (CC) Weld Output
Terminal
3 Wire (CV) Weld Output Terminal
For MIG welding, connect work cable
to Work terminal and wire feeder
cable to Wire (CV) terminal.
For Stick welding, connect work
cable to Work terminal and electrode
holder cable to Stick/TIG (CC)
terminal.
For TIG welding, connect work cable
to Stick/TIG (CC) terminal and elec-
trode holder cable to Work terminal.
Tools Needed:
2 3
!
Stop engine.
!
Failure to properly connect
weld cables may cause ex-
cessive heat and start a fire,
or damage your machine.
.
Do not place anything between
weld cable terminal and copper
bar. Make sure that the sur-
faces of the weld cable terminal
and copper bar are clean.
1 Correct Weld Cable
Connection
2 Incorrect Weld Cable
Connection
3 Weld Output Terminal
4 Supplied Weld Output
Terminal Nut
5 Weld Cable Terminal
6 Copper Bar
Remove supplied nut from weld
output terminal. Slide weld cable
terminal onto weld output terminal
and secure with nut so that weld
cable terminal is tight against cop-
per bar.
3/4 in.
804 857-C / Ref 245 069-A
803 778-B