Table of Contents
Advertisement
Figure 24
1. Nozzle guides
Adjusting the Belt
Service Interval: After the first 8 hours
Every 50 hours
If the belt slips when changing the direction of the nozzle, an
adjustment to the belt is required.
1. Loosen the bolts securing the pulley mounting bracket
to the blower frame
2. Position a torque wrench into the pulley mounting
bracket
(Figure
25).
3. Pivot the pulley mounting bracket away from the
nozzle until the torque wrench reads 22.6 to 26.0 N-m
(200 to 230 in-lb)
(Figure
4. Tighten the mounting bolts.
1
G017855
(Figure
25).
25).
1
1 5
1. Mounting bolts
2. Pulley
3. Hole for torque wrench
23
3
4
Figure 25
4. Torque wrench in pulley
mounting bracket [22.6
to 26.0 N-m (200 to 230
in-lb)]
5. Belt
2
G015845
Advertisement
Table of Contents
