Servicing The Fuses; Jump-Starting The Machine - Toro 72958 Operator's Manual

Installing the Battery
Note:
Position the battery in the tray with the terminal
posts opposite from the hydraulic tank
Figure 57

Servicing the Fuses

The electrical system is protected by fuses. It requires
(Figure 57).
no maintenance, however, if a fuse blows check the
component/circuit for a malfunction or short.
The fuses are located on the console to the right of
the seat
1.
2.
g032526
1. Optional accessory (15 A)
2. Charge (25 A)
3. PTO (10 A)

Jump-Starting the Machine

1.
47
(Figure 58).
To replace the fuses, pull out on the fuse to
remove it.
Install a new fuse (Figure
Figure 58
Check and clean corrosion from the battery
terminals before jump-starting. Ensure that the
connections are tight.
CAUTION
Corrosion or loose connections can
cause unwanted electrical voltage spikes
at any time during the jump-starting
procedure.
Do not attempt to jump-start the machine
with loose or corroded battery terminals,
or damage to the engine or EFI may
occur.
58).
g008966
4. Main (25 A)
5. Console