On Network page you can configure the IP address of the standalone EAP.
Dynamic/Static:
By default, the EAP device obtains an IP address from a DHCP server (typically a
router). You can also select Static to configure the IP address manually.
Fallback IP:
If the EAP fails to get a dynamic IP address from a DHCP server within ten
seconds, the fallback IP will work as the IP address of the device. After that,
however, the device will keep trying to obtain an IP address from the DHCP
server until it succeeds.
DHCP Fallback
Enter the fallback IP/IP mask.
IP/IP MASK:
DHCP Fallback
Enter the fallback gateway.
Gateway:
Chapter 4 Network
Figure 4-1 Network Page
7