TP-Link EAP320 User Manual page 46

Subnet Mask: Displays the subnet mask of the device.
LAN Port1/ LAN Displays the maximum transmission rate and duplex mode (half-duplex or
full-duplex) of the port.
Port2:
Client

Displays the MAC address of the client of the AP selected in AP List.
MAC:
SSID: Displays the SSID the client is connected to.
SNR(dB): Signal to Noise Ratio, the power ratio between the received wireless signal
strength and the environmental noise strength. The bigger the value of SNR is, the
better network performance the device provides.
CCQ(%): Displays the wireless Client Connection Quality (CCQ). CCQ refers to the ratio of
current effective transmission bandwidth and the theoretically maximum
available bandwidth. CCQ reflects the actual link condition.
Displays the data rate at which the client transmits wireless packets.
Rate(Mbps):
Down(Byte): Displays the throughput of the downstream data.
Up(Byte): Displays the throughput of the upstream data.
Active Time: Displays the amount of time the client has been connected to the device.
LAN Traffic

Click LAN Traffic and you can monitor the data transmission status of the LAN port.
Figure 6-6 Client
Figure 6-7 LAN Traffic
40